network note

Upload: encik-bass

Post on 04-Jun-2018

215 views

Category:

Documents


0 download

TRANSCRIPT

  • 8/13/2019 Network Note

    1/9

    Introduction

    Dalam pengendalian rangkaian kawasan setempat, bagaimana merancang dan mengendalikan

    pengguna, kumpulan, sumber fail, mesin pencetak, mesin faks, sambungan talian rangkaian,

    perkongsian dan sebagainya merupakan perkara yang penting.Sumber pada rangkaian perlu mempunyai

    satu nama tunggal yang boleh dibezakan oleh pengguna.Nama tersebut akan direkodkan dalam

    perkhidmatan direktori.Sejak Windows 2 Ser!er, perkhidmatan direktori telah diubah kepadaActive

    Directory (AD)."ni merupakan suau re!olusi yang besar, tetapi telah menyebabkan kecekapan

    keseluruhan perlaksanaan menurun.Dalam Windows Ser!er 2#,Active Directorytelah

    mempertingkatkan kecekapan banyak fungsi.Semua sumber akan bergabung denganActive Directory,

    termasuk keselamatan dan perkhidmatan rangkaian.

    BUS NETWORK STRUCTURE

    A bus network consists of a continuous length of cable that connects two or more devices together. A bus network is

    also called a backbone network.

  • 8/13/2019 Network Note

    2/9

    How Information Transfers

    On a bus network, only one computer can transfer information at a time. When a computer sends information moves

    through the entire length of the cable. The destination computer must retrieve the information from the cable.

    Terminators

    A terminator is a device that absorbs the signals transmitted on a network cable. Each end of the cable on a busnetwork must have a terminator. Terminators prevent signal from being bounced back along the cable and causinginterference. The type of terminator required depends on the type of cable used on the network.

    Setup

    The setup of a bus network is simple. Each computer must be connected to a single length of

    cable. A bus network is often used to connect a few computers located in a small area, such as

    an office.

    Expansion

    Epanding an eisting bus network can be difficult. When adding a computer a computer to a bus network, the cable

    must be broken to etend the cable and attach the computer. The other computers on the network cannot echangeinformation while the cable is broken.

    Repair

    If a computer is malfunctioning and causing a problem on the cable, the entire network will

    affect. This can make the cause of a problem difficult to isolate and repair.

    Cost

    !us networks are quite inepensive. "ost bus networks use a single piece of copper cable to

    connect its computers together.

    Domain

  • 8/13/2019 Network Note

    3/9

    Domain merupakan teras Struktur logik dalamActiveDirectory.$mumnya, domain sesuai

    digunakan pada rangkaian organisasi yang besar kerana ia dapat membekalkan pengendalian akaun dan

    perkongsian maklumatpeer-to-peer.Domain mempunyai perbezaan yang besar dengan kumpulan.

    %umpulan akan dibentuk apabila beberapa buah komputer yang mempunyai sifat tugas yang sama

    bersambung antara satu sama lain menerusi rangkaian. %omputer yang berada dalam satu kumpulan

    boleh saling mengongsikan maklumat, iaitu Struktur Peer-to-Peer.&leh kerana tidak mempunyai

    komputer pengendalian pusat, maka setiap stesen kerja turut mempunyai akaun dan kata laluan sendiri.

    &leh itu, pengendali perlu membina'menyingkir'mengubah akaun pengguna dan kebenaran kumpulan

    yang lain pada setiap stesen kerja.

    "ni akan membebankan pengendali. Selain daripada itu, jika anda ingin mengubah kata laluan, makaanda perlu melakukannya pada setiap stesen kerja. (ara ini boleh digunakan pada organisasi yang kecil.)anakala untuk sistem rangkaian yang lebih besar, konsep domain diperlukan untuk menyelesaikanmasalah tersebut.

    *angkah kerja +

    1. Creating a domaincontroller. a. #t all begins with a simple command. $tart was clicked, run,and %dcpromo& was typed as below.

    b. The Wi'ard appears as below. (et was clicked.

  • 8/13/2019 Network Note

    4/9

    c. Then, the information bo was read and (et clicked.

    d. )omain controller for a new domain selected.

    e. Then, domain in a new forest was selected.

  • 8/13/2019 Network Note

    5/9

    f. *ull )($ name was filled with %+kdomain.local&.

    g. (et it asked for the (ET!#O$ name. This is the naming

    conventions older operating systems such as Windows (Tuse. )efaults were selected.

  • 8/13/2019 Network Note

    6/9

    h. Then, location for database folder and log folder was

    inserted .#deally for increased performance store thedatabase and log on separate drives.

    i. %#nstall and onfigure )($ on this computer& was selected.

    +. -ermission wi'ard appeared on net. %-ermissionompatible only with Windows /// or Windows $erver

    //0 operating systems& was selected.

  • 8/13/2019 Network Note

    7/9

    k. Window restore password was entered and (et clicked.

    l. (et was clicked on the summary to begin operation.

    m. The Active )irectory #nstall then began.

    n. )o (OT click cancel, it will probably end up with the server

    needing to be formatted if you do.

  • 8/13/2019 Network Note

    8/9

    o. When complete installation prompted, *inish was clicked.

    p. omputer was 1estarted.

    q. After restarted, #- address was inserted.

    r. !egin configuration by right2clicked on network connection

    tray icon.

    s. Then, a network connection windows appeared. 3ocal Areaonnection was right2clicked to open sub menu option.

    t. Propertieshad been selected.

  • 8/13/2019 Network Note

    9/9

    u. When properties windows appeared, #nternet-rotocol4T-5#-6 had been highlighted and properties was

    clicked.

    v. 7ere, the #- address can be insert manually if there8s any.w. %9:.9;